Fixed Automatic Fertigation Station for Irrigation Headworks

A permanent feeding point

This fixed automatic fertigation station brings water and fertilizer feeding equipment together at a permanent irrigation headworks. It is intended for farms or protected cropping layouts where the supply, downstream zones and service area are established. A fixed installation makes it possible to plan the feeding equipment and pipework around one accessible operating point.

Configure the station around the water duty

Start with the source-water quality, available inlet pressure and the flow required by each irrigation zone. Specify the fertilizer feeding duty, number of independently prepared solutions and the intended operating schedule. These details determine the suitable pump, injection arrangement, filtration and control configuration. Agree the complete build for the actual crop and irrigation plan.

Confirm the supplied equipment

The fixed station is supplied to an agreed project configuration. Confirm the pumps, filters, fertilizer tanks, dosing channels, controller and measurement equipment included in that build. Agree electrical requirements, connection sizes and the functions available to the operator. A photograph does not establish tank capacity, treatment performance or the number of dosing channels.

Prepare the installation and service access

Provide a stable installation area with access for operators and maintenance. Plan pipe support, drainage and the position of the fertilizer preparation area before the station is installed. Provide the required water, power and discharge connections. Include source-water backflow protection and check that maintenance access remains available after connecting the system. Arrange handling and storage for fertilizers in line with the site operating procedure.

Commission the irrigation and feeding settings

Test water operation first, then check solution delivery at the actual flow and pressure. Verify the selected concentration and the distribution through the intended irrigation zone. Where the agreed configuration includes measurement or automatic feedback, calibrate it using the supplied procedure. Repeat the operating checks when the source, zone demand or fertilizer preparation changes.

Request a project quotation

Share the water source, flow, pressure, power supply, crop blocks and feeding requirements when requesting supply. Include the installation location or intended mobile operating sites and any automation requirements. Agree the equipment list, operating limits and commissioning scope before ordering a complete unit.