Lever Hole Punch for Drip Irrigation Tubing

The open jaw locates the tube beneath the working tip, while the long blue lever provides a clear hand-operated action. It suits the task of adding individual emitter outlets along an existing soft irrigation lateral, where placing each opening beside the plant is more useful than drilling an arbitrary spacing.

Select the opening for your fitting

The 3 mm/4 mm listing is one combined option. It does not mean two tools, two included tips or an adjustable cutter. Confirm the supplied cutting tip before ordering. The hole diameter must match the emitter inlet or takeoff barb; it is a different measurement from the outside diameter of the tube. Rigid PVC use is not established for this punch.

Prepare and make the opening

Shut off and drain the lateral, then mark the outlet locations while the tube lies in its intended route. Hold the tube in the jaw without flattening it unnecessarily. Align the cutting point over the mark, squeeze steadily and release before moving the tool. Inspect a test opening on spare tubing before punching a full row.

Finish the connection and care for the tool

Clear loose material from the opening and flush the line before inserting emitters. Seat each barb squarely, restore water gradually and inspect for seepage. A fitting that rocks in an enlarged hole needs a suitable repair rather than more force. Store the punch with the working tip protected and keep the jaw free of grit.