T-Handle Irrigation Hole Punch

A wide orange grip sits above a straight metal shaft and a dark cylindrical cutting head. The T-shaped handle provides two sides to hold while placing the cutter over a planned takeoff. This manual format is useful when the installer needs direct control of a single opening rather than the squeeze action of a plier tool.

Select the opening for your fitting

Confirm the supplied cutter diameter before ordering and match it to the fitting or sealing grommet. The diameter of the mainline does not specify the size of the takeoff hole. The tubing or hose material, wall thickness and required opening all affect suitability; do not assume this tool covers every soft pipe or layflat connection.

Prepare and make the opening

Isolate and drain the line, then secure a spare section for a trial opening. Mark the center and align the head squarely to the wall. Keep hands below the grip clear of the cutter. Apply controlled force without allowing the tube to roll or collapse, and stop if the material splits or requires excessive pressure.

Finish the connection and care for the tool

Remove the cut piece and clear the opening before assembly. Fit the intended connector exactly as its installation instructions require, including the correct seal where applicable. Flush debris from the line and check the joint under operating pressure. Clean and dry the cutting head after work; store it so the exposed edge cannot contact loose fittings or hands.