Barbed Irrigation Elbow Connector | 16–32 mm

This barbed irrigation elbow joins two tubing sections at a right angle. Its curved black body changes the direction of the water line while keeping the connected runs close to the corner. Choose from the listed 16 mm, 20 mm, 25 mm and 32 mm options after checking your tubing.

Turn a corner with a fitted joint

Use the elbow where a straight run needs to follow the edge of a planting bed or turn toward another irrigation row. A defined corner can make the layout easier to inspect and support. Leave enough room on both sides to seat the tubing fully and reach the joints for later checks.

Check the tubing before fitting

Compare the selected connection size with the tubing inside diameter and check that the tubing type is suitable for a barbed joint. A nominal size printed on a tube may describe another measurement, so verify the actual fit rather than relying on the label alone. Inspect the cut ends and remove any section that is split, distorted or damaged.

Install and inspect the assembly

Turn off the water supply and release pressure before working on the line. Make clean, square cuts where needed and keep dirt out of the open tubing. Seat each compatible connection fully without twisting the finished assembly out of position. If your tubing system calls for additional retention, use the appropriate matching hardware.

Restore water gradually and inspect every new joint for seepage or movement. Check again during the first watering cycle, especially after repositioning the line. Isolate the supply before correcting a loose connection. Confirm the pressure and temperature limits of the complete tubing system before putting it into regular service.