Open-Ring Irrigation Pipe Hook for Suspended Tubing

Inspect the connection shape

This open-ring irrigation pipe hook holds a matching tube beside a suspension point. The curved lower cradle surrounds the tube while the smaller curled upper end provides the hanging connection. The product view shows the hook shape rather than a measured size or a complete installation.

Select the tube size

• 12 mm and 16 mm options.
• 20 mm and 25 mm options.
• 32 mm option.

Measure the outside diameter of the tube that needs support and select the corresponding hook. Check the actual fit on a short section before laying out the whole run. The tube should sit in the cradle without being crushed, flattened or forced through a smaller opening.

Plan a supported irrigation route

Place the tube along its intended route before choosing the suspension points. Leave room around bends and fittings, and arrange the supports so the line does not pull against a dripper connection or a branch takeoff. The hook supports the pipe externally; it does not join pipe ends or create a watertight seal.

Check the hanger and line together

Confirm that the upper hook fits the intended support and stays seated when the tube is in position. Select support spacing for your particular tube, filled line weight and mounting arrangement. No universal spacing or load capacity is specified here. Run the irrigation zone, check for sagging or sharp bends and adjust the route where needed. Inspect the support after moving the line or working around the plants, especially where handling could unseat the hook.