16 mm Drip Tape Valve for Layflat Hose, Split Body

This 16 mm drip tape valve connects a tape row to a layflat irrigation supply hose and provides a manual shutoff at the takeoff. Its split central body carries a round green control handle, a tape outlet with a green retaining nut, and a hose-side attachment with a threaded section and winged retaining piece.

Control the row at the supply hose

A layflat supply distributes water along the field while individual tape rows carry it toward the crop. Placing a valve at the transition keeps the row control close to the supply connection. Leave enough clearance around the handle and the hose attachment to operate and inspect the fitting after the tape is laid out.

Match the takeoff and tape separately

• Tape selection: 16 mm.
• Outlet: tape insert with a green retaining nut.
• Inlet: layflat takeoff attachment with a winged retaining piece.
• Body: split construction beneath the round green handle.

The 16 mm size identifies the tape selection; it does not identify the overall diameter of the layflat hose. Confirm the hose wall construction, required opening and attachment method before installation. Check tape dimensions and operating requirements independently so the supply connection and the row connection both suit the planned system.

Install with room for inspection

Turn off the supply and drain pressure from the hose before making or servicing a takeoff. Keep the attachment surfaces clean and prepare the hose connection using the method confirmed for this fitting. Seat the tape fully on its outlet insert and secure the nut without creasing the tape. Align the row to avoid pulling the valve sideways as the hose fills. Bring water on gradually, inspect the hose attachment and tape outlet, and check again after the first complete irrigation run.

Sold as one valve. Layflat hose, drip tape and separate preparation tools are supplied separately.