Large-Body Locking Takeoff Valve for Drip Tape

This large-body locking takeoff valve connects the start of a drip tape row to its supply connection and provides manual control at the row entrance. A barbed inlet and locking tape outlet serve different sides of the connection.

Identify the inlet and tape outlet

The tape end uses a locking nut to retain the tape on the outlet. The smaller barbed end is the supply-side inlet. This is a row-start takeoff arrangement rather than a valve for joining two lengths of drip tape end to end.

The available tape options are 16 mm and 20 mm. These labels do not specify the inlet barb diameter or the required mainline hole. Confirm tape dimensions, wall thickness and the supply-side connection before selecting the valve.

Control one row at its start

The manual handle lets you open or close the connected row while managing the irrigation layout. Use row isolation when a section needs attention or is temporarily unused. Keep the handle accessible and support the supply and tape so they do not strain the connections.

Check installation requirements

1. Stop the water and relieve system pressure.
2. Confirm the correct supply opening and any required sealing accessory before fitting the inlet.
3. Cut the tape end cleanly, seat it on the outlet and secure it with the locking nut.
4. Restore water gradually, operate the handle and inspect both connections for leakage.

Do not choose a punch size from tape diameter alone. Use confirmed inlet dimensions and supply pipe requirements. Keep operating pressure within the limits of the tape and complete system.

What is included?

The selected option is one takeoff valve. Supply pipe, drip tape, hole punch and separate seals are not included. The large-body designation identifies this valve format; it does not by itself establish a higher pressure or flow rating.