16 mm Wide-Body Lock-Ring Tee for Layflat Hose

A branch connection for your drip layout

The wide center body carries a broad upper mounting collar and a flat top profile above two opposing locking-ring line ends. Choose this version when its larger center fitting matches the layflat hose connection in your irrigation layout. The blue side rings identify the two drip line connection positions.

Match every connection

Compare the wider mounting body with the hose fitting you intend to use. Body width alone does not establish a larger flow capacity or a different pressure rating. Check the center sealing profile and hose opening requirements before installation.

The listed drip line connection is 16 mm. Match the line type and wall construction to the locking-ring ends as well as checking the diameter. Plan the line route so that the fitting sits without pulling, twisting or sharply bending the connected tubing.

Prepare and install

Lay out the branch positions before cutting any line. Make clean, square cuts and keep loose particles away from the connection surfaces. Flush the supply line before completing the connections so that installation debris does not travel farther into the irrigation system. Seat each line end fully and secure its locking ring according to the connection arrangement.

Check during the first watering run

Start the irrigation supply gradually and inspect all three connection points while water is flowing. Look for drips around the line ends and center connection, and confirm that the connected runs receive water. If a joint leaks, stop the supply and check alignment and seating before running the system again. Keep the fitting accessible for seasonal inspection and for any later change to the branch layout.

• 16 mm listed drip line connection
• Two opposing locking-ring line ends
• Wide center mounting body
• Connection fit checked at all three points