16 mm Drip Line Tee with 6 mm Micro-Sprinkler Outlet

Take a small irrigation branch from a 16 mm line without ending the main run. This tee has two opposed lock-nut connections for the 16 mm tubing and a central 6 mm outlet for a compatible micro-tube or sprinkler connection. It is useful when a crop row needs a separate emitter above or beside the main drip line.

Three connections, two flow paths

The straight connections continue the supply line through the tee. The narrow upright branch feeds a single micro-irrigation point. Its branch is much smaller than the run, so it should not be used as a 16 mm three-way junction or as a reducer for a second main line. Check the outside diameter of the branch accessory before ordering; a nominal 6 mm label alone does not establish a seal with every tube wall or sprinkler stem.

Plan the branch position

Locate the tee where the extra emitter can be reached for cleaning and inspection. Leave enough slack in the micro-tube to route it to the plant without pulling the branch sideways. Keep the supply tube supported on both sides so movement of the line does not twist the center outlet.

Connect and test

Shut off the supply and relieve pressure. Cut the 16 mm line squarely, slide the locking nuts back, seat the two tube ends fully over the fitting inserts, then tighten the nuts by hand. Fit the compatible 6 mm branch accessory and restore water slowly. Check all three joints while the system runs.

Sold as one tee fitting. The sprinkler shown in the product illustration demonstrates a possible branch connection; tubing, sprinkler and other installation parts are not included unless listed in your selected option.