Straight Irrigation Hose Coupling - 32 to 110 mm

This straight irrigation hose coupling joins two compatible hose sections along the same run. Its two ribbed tails fit inside the hose ends, creating a direct connection without a threaded transition. Use it to connect separate lengths or replace a damaged joint where the surrounding hose remains suitable.

Connection layout

Both hose ends approach the coupling in a straight line. The broad retaining ribs are visible at each end, with a central body between them. Select the same listed connection size for both sections; this equal coupling does not provide a step down to a smaller hose.

Available sizes

Listed options: 32, 40, 50, 63, 75, 90 and 110 mm.

Check the actual hose dimensions and construction against the fitting before ordering. Listed metric sizes identify the available options; they do not establish compatibility with every hose carrying a similar nominal label. Confirm the required retaining hardware and operating limits for the complete hose assembly.

Plan the hose route

Position the joint where it can be reached for inspection. Keep the two runs aligned and supported so hose weight or movement does not pull the tails sideways. Allow sufficient straight hose beside each connection rather than placing a sharp fold immediately next to the body.

Install and check the connection

Stop the water supply and release trapped pressure before installation. Prepare a clean, square hose end and keep the insert free from dirt. Seat the hose fully over the retaining ribs and secure it with the retention specified for that hose combination. Restore water gradually, inspect the connection and release pressure again before making adjustments.

Sold as one fitting. Hose and installation accessories are separate.