Four-Way Layflat Hose Cross Connector, 50–110 mm

This four-way layflat hose cross connector brings four hose runs together at a single junction. Its four hose ends form a cross, with two pairs of opposite connections. Each end has broad retaining ribs for the hose connection, giving the fitting a different connection form from a small drip-tubing cross.

Select the hose size

Choose from 50, 63, 75, 90 or 110 mm listed sizes. The selected size applies to all four hose ends; this cross does not provide a reducing branch or a threaded outlet. Confirm that every hose entering the junction is suitable for the selected fitting.

Check the fitting guidance for the hose and the dimensions of the existing assembly before ordering. Diameter labels on small irrigation tubing and layflat hose are not interchangeable. The product photograph shows the connection form, while the selected option identifies the size you will receive.

Plan the junction

Allow enough space for four hose approaches without tight bends immediately beside the fitting. Position the cross where it can be inspected and where moving equipment will not pull directly on the joints. A cross creates a connected junction; it does not independently shut off or regulate any branch.

Secure and test each connection

Isolate and depressurize the supply before assembly. Inspect the hose ends and fitting for damage, seat each hose fully and use securing hardware appropriate to the confirmed hose connection. Keep the junction supported rather than suspended by one hose.

Restore water gradually and inspect all four joints under normal operation. If a connection shifts or leaks, stop the supply before correcting it. Browse irrigation fittings for the remaining connections in the layout.