Irrigation Hose End Plug with Loop - 50 to 110 mm

This irrigation hose end plug closes the open end of a compatible hose run. The ribbed insert fits inside the hose, while the loop projects beyond the end for access. Choose it for a terminal connection where the hose should stop rather than continue through another fitting.

Connection layout

The plug has a closed end, broad retaining ribs and an external loop. It provides a terminal closure rather than a flow-through coupling. Select the listed size for the actual hose connection; the loop does not establish a pressure rating or replace the retention required by the hose system.

Available sizes

Listed options: 50, 63, 75, 90 and 110 mm.

Check the actual hose dimensions and construction against the fitting before ordering. Listed metric sizes identify the available options; they do not establish compatibility with every hose carrying a similar nominal label. Confirm the required retaining hardware and operating limits for the complete hose assembly.

Plan the hose route

Place the hose end where it can be inspected and serviced. Leave clearance around the loop and keep the terminal section supported. If the line needs periodic flushing, plan a safe way to release pressure and open the end; never pull the plug from a pressurized hose.

Install and check the connection

Stop the water supply and release trapped pressure before installation. Prepare a clean, square hose end and keep the insert free from dirt. Seat the hose fully over the retaining ribs and secure it with the retention specified for that hose combination. Restore water gradually, inspect the connection and release pressure again before making adjustments.

Sold as one fitting. Hose and installation accessories are separate.