90-Degree Irrigation Hose Elbow - 32 to 110 mm

This 90-degree irrigation hose elbow changes the direction of a hose run at a right-angle corner. Its two ribbed tails connect to compatible hose ends, providing a defined bend at the junction. Choose it where the layout requires a corner and the hose should approach each connection without being sharply folded.

Connection layout

The elbow has two equal-size hose connections arranged at 90 degrees. Each tail carries broad retaining ribs. Select the listed connection size to suit both hose sections; the fitting changes direction without converting between different diameters or adding a threaded connection.

Available sizes

Listed options: 32, 40, 50, 63, 75, 90 and 110 mm.

Check the actual hose dimensions and construction against the fitting before ordering. Listed metric sizes identify the available options; they do not establish compatibility with every hose carrying a similar nominal label. Confirm the required retaining hardware and operating limits for the complete hose assembly.

Plan the hose route

Lay out the corner before cutting the hose. Allow room for the elbow body and any retention hardware required by the hose system. Support both legs so adjacent hose runs do not twist the bend or impose sideways force on either joint. Keep the corner accessible during watering.

Install and check the connection

Stop the water supply and release trapped pressure before installation. Prepare a clean, square hose end and keep the insert free from dirt. Seat the hose fully over the retaining ribs and secure it with the retention specified for that hose combination. Restore water gradually, inspect the connection and release pressure again before making adjustments.

Sold as one fitting. Hose and installation accessories are separate.