Equal Irrigation Hose Tee - 32 to 110 mm

This equal irrigation hose tee creates a three-way junction, with a straight run and a branch at right angles. Three ribbed hose tails connect to compatible hose sections. Use it when the layout needs a branch from an existing route, selecting a size that fits all three connecting sections.

Connection layout

All three connections use the same listed size. The tee is an equal junction rather than a reducing fitting, so a smaller branch requires a separate compatible transition. Its broad hose-tail ribs are visible on the two straight ports and the center branch.

Available sizes

Listed options: 32, 40, 50, 63, 75, 90 and 110 mm.

Check the actual hose dimensions and construction against the fitting before ordering. Listed metric sizes identify the available options; they do not establish compatibility with every hose carrying a similar nominal label. Confirm the required retaining hardware and operating limits for the complete hose assembly.

Plan the hose route

Plan the three runs before making cuts. Leave room around the branch for the hose to approach without folding beside the fitting. Support the surrounding sections so their combined weight does not pull on the junction. A tee creates a branch, but water distribution depends on the complete system layout.

Install and check the connection

Stop the water supply and release trapped pressure before installation. Prepare a clean, square hose end and keep the insert free from dirt. Seat the hose fully over the retaining ribs and secure it with the retention specified for that hose combination. Restore water gradually, inspect the connection and release pressure again before making adjustments.

Sold as one fitting. Hose and installation accessories are separate.